NB: If boat is sailing but is also equipped for use as a non-sailing boat, both must be examined
2 and 3 Option selected:
units Required Actual Pass/Fail
4 Downflooding openings: are all requirements met?
Downflooding height: Worksheet employed for basic height
basic requirement m W
4 or 5 reduced height for small openings (sheet 4 only) m W
reduced height at outboard (options 1 + 3 only) m W
increased height at bow (options 1, 3, 5, 6 only) m W
4 Outboard boats when starting: Are all requirements met? YES / NO?
Offset load test:
6 residual freeboard mm W
option 2 boats: maximum heel angle degrees<
Flotation test: (options 1, 6, 8 and 9 only) all preparations completed? YES / NO
For Level Flotation assess items markeda, for Basis Flotation those markedb
7 Swamped stabilitya : 5 min after swamping, does boat heel less than 45°?
Load Testb: 5 min after swamping, does boat float level with 2/3 showing?
One Person Testa: 5 min after swamping, does boat float so that it can be bailed?
Flotation elementsb: do all elements comply with all the requirements?
8 Basic Flotation by calculation: value of mTEST/VB < 930
9 Capsize Recovery Test: (options 3 + 7 only) are all requirements met?
Design Category recommended by the builder ///////////////
10 Knockdown Recovery Test: (options 8 + 10 only) PASS / FAIL?
method used = experimental or theoretical?
11 Wind Stiffness Test: (options 9 + 11 only) Cat CvW = m/s W 11
was reefed sail area used? (i.e.: are warning labels required?) ///////////////
Cat D vW = m/s W 6
was reefed sail area used? (i.e.: are warning labels required?) ///////////////
NB: Boat must pass all requirements applicable to option to be given intended Design Category.
Design Category given: Assessed by:
ISO/FDIS 12217-3:2002(E)
© ISO 2002 – All rights reserved 47
Annex ZA
(informative)
Clauses of this European Standard addressing essential requirements or
other provisions of EU Directives
By agreement between ISO and CEN, this CEN annex is included in the DIS and the FDIS but will not appear in
the published ISO standard.
This European standard has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association and supports essential requirements of EU Directive 94/25/EC.
WARNING — Other requirements and other EU Directives may be applicable to the product(s) falling within the
scope of this standard.
The following clauses of this standard, as detailed in Table ZA.1, are likely to support requirements of Directive
94/25/EC.
Compliance with the clauses of this standard provides one means of conforming with the specific essential
requirements of the Directive concerned and associated EFTA regulations.
Table ZA.1 — Correspondence between this European Standard and EU Directives
Clauses/sub-clauses
of this European
Standard
Corresponding annexes/paragraphs
of Directive 94/25/EC Comments
5, 6, 7, 8,
Annexes A, B, C,D
Annex I, Clause 3.2, Stability and Freeboard,
Clause 3.5, Flooding, and Clauses 3.6 and
Other pages: : <<Prev * 1 * 2 * 3 * 4 * 5 * 6 * 7 * 8 * 9 * 10 * 11 * 12 * 13 * 14 * 15 * 16 * 17 * 18 * 19 * 20 * 21 * 22 * 23 * 24 * 25 * 26 * 27 * 28 * 29 * 30 * 31 * 32 * Next>>
|
You are here:ASK Boat
-> EN ISO Rules
-> Content
Category: Home
-> EN ISO Rules