member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental and non-governmental, in
liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
International Standard ISO 13590 was prepared by Technical Committee ISO/TC 188, Small craft.
Annex A of this International Standard is for information only.
DRAFT INTERNATIONAL STANDARD © ISO ISO/DIS 13590:2001
© ISO 2001 – All rights reserved 1
Small craft — Personal watercraft — Construction and system
installation requirements
1 Scope
This International Standard applies to personal watercraft as defined in 3.1, for construction and installation of
builder's plate permanently installed petrol fuel systems, electrical systems, steering system, ventilation, hull
structure and floatation, and requirements for stability, freeboard and owner's manual.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of
this part of ISO 13590. For dated references, subsequent amendments to, or revisions of, any of these publications
do not apply. However, parties to agreements based on this part of ISO 13590 are encouraged to investigate the
possibility of applying the most recent editions of the normative documents indicated below. For undated
references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain
registers of currently valid International Standards.
ISO 1402:1994, Rubber and plastics hoses and hose assemblies — Hydrostatic testing.
ISO 1817:1985, Rubber, vulcanized — Determination of the effect of liquids.
ISO 7326:1991, Rubber and plastics hoses — Assessment of ozone resistance under static conditions.
ISO10240:1995, Small craft—Owner's manual
ISO/DIS 14945:1999, Small craft-Builder's plate
ISO 7840:1994, Small craft — Fire-resistant fuel hoses.
ISO 8469:1994, Small craft — Non-fire-resistant fuel hoses.
ASTM D 380:1994, Methods of Testing Rubber Hose.
ASTM D 413:1993, Test Method for Rubber Property — Adhesion to Flexible Substrate.
ASTM D 471:1996, Test Method for Rubber Property — Effect of Liquids.
ASTM D 573:1994, Test Method for Rubber — Deterioration in an Air Oven.
ASTM D 1621:1994, Compressive Properties of Rigid Cellular Plastics.
SAE J378: 1988, Marine Engine Wiring.
Other pages: : <<Prev * 1 * 2 * 3 * 4 * 5 * 6 * 7 * 8 * 9 * 10 * 11 * 12 * 13 * 14 * 15 * 16 * 17 * 18 * Next>>
|
You are here:ASK Boat
-> EN ISO Rules
-> Content
Category: Home
-> EN ISO Rules